IM 701450-02E
11
Basic Jog Shuttle Operation
Selecting an Item Entering Numerical Values
RESET
SELECT
Jog shuttle
Move to the next item down.
Move to the next item up.
Restores the setting to its initial value.
Arrow keys
Moves the digit selection cursor to the
left or right.
Jog shuttle
Shuttle ring
The angle of rotation of the ring determines the rate
of change.
Increases (or speeds up) the
setting value.
Decreases (or slows down) the
setting value.
RESET
SELECT
Basic Key and Jog Shuttle Operation
Using a USB Mouse
Introduction to main functions User’s manual section 4.3, “Operating the DL7400
Using a USB Keyboard or USB Mouse.”
If you connect a USB mouse to the USB PERIPHERAL connector on the rear panel of the instrument, you can use
the mouse to perform the same operations available with the front panel keys.
Top menu
Right click in the display (waveform display frame) to display the
top menu containing all the names of the front panel keys.
Pointer
Move the pointer to the desired item,
click it, and the corresponding setup
menu appears.
Sub menus
A sub menu is displayed when clicking on a top menu
item accompanied by an arrow (>).
If you move the mouse pointer to
this position, the pointer changes
from a to a .
In this mode, if your mouse has a
wheel you can use it to change
the T/div setting.
If you move the mouse pointer to
this position, the pointer changes
from a to a .
In this mode, if your mouse has a
wheel you can use it to change the
V/div setting.
DL7400
USB mouse (with wheel)
USB PERIPHERAL connector (rear panel)
To Next Page
Loading...
