IM 701450-02E
17
Working with the DL7400
Working with the DL7400
Working with the DL7400
This section provides an example of how you can observe a probe compensation signal being output from the DL7400.
Preparing for an Observation
Connecting the Power Supply
User’s manual section 3.3, “Connecting the Power Supply and Turning ON/OFF the Power Switch”
Before connecting the power supply, you must read the warnings in the user’s manual listed in
section 3.3, “Connecting the Power Supply and Turning ON/OFF the Power Switch.”
3-prong outlet
Power cord (accessory)
Power connector
Rated supply voltage: 100 to 120 VAC/200 to 240 VAC
Permitted supply voltage range: 90 to 132 VAC/180 to 264 VAC
Rated power supply frequency: 50/60 Hz
Permitted power supply frequency range: 48 to 63Hz
Rear panel
Turning the Power Switch ON and OFF
User’s manual section 3.3, “Connecting the Power Supply and Turning ON/OFF the Power Switch”
OFF ON
Power switch
Front panel
To Next Page
Loading...
