IM 701450-02E
18
Connecting the Probe
User’s manual section 3.4, “Connecting the Probe”
User’s manual section 3.5, “Compensating the Probe (Phase Correction)”
Before connecting the probe, you must read the warnings in the user’s manual listed in
section 3.5, “Compensating the Probe (Phase Correction).”
Phase adjustment hole
Functional ground terminal
Probe compensation
signal output terminal
Probe
• For instructions on how to connect a logic probe, see section 3.6.
• When actually making waveform observations using the probe, you must follow the procedures in the user’s manual for
probe phase correction (section 3.5), and calibration (section 4.6). Failure to use the probe correctly will result in incorrect
waveforms.
Note
Working with the DL7400
To Next Page
Loading...
