Toc-1
<Int> <Ind> <Rev>
TI 05C01E02-01E 1st Edition : Oct. 31, 2001-00
UT130, UT150/UT152/UT155
Temperature Controller
TI 05C01E02-01E 1st Edition
CONTENTS
INTRODUCTION .................................................................................................... i
1. DESCRIPTION OF TEMPERATURE CONTROL ........................................... 1-1
2. INFORMATION TO ORDER A CONTROLLER .............................................. 2-1
2.1 Model and Suffix Codes ......................................................................................... 2-1
2.2 Mandatory Items to Specify ................................................................................... 2-5
2.3 Optional Suffix Codes to Specify........................................................................... 2-5
2.4 Other Items to Specify............................................................................................ 2-6
2.5 User’s Manual .......................................................................................................... 2-8
3. NAMES AND FUNCTIONS OF EACH PART / PARAMETER......................... 3-1
3.1 UT130 Names and Functions of Each Part (Principles of Key Operation)........... 3-1
3.2 UT130 Parameter Flowchart and Description ....................................................... 3-2
3.3
UT150/UT152/UT155Names and Functions of Each Part (Principles of Key Operation) ....
3-6
3.4 UT150/UT152/UT155 Parameter Flowchart and Description ................................ 3-8
4. BASIC OPERATIONS .................................................................................... 4-1
4.1 Setting Measured Input Type and Scale (Setting First)......................................... 4-1
4.2 Setting Control Action ............................................................................................ 4-5
4.2.1
Selecting a Control Mode (Dynamic Auto Tune Control / PID Control / ON-OFF Control) ....
4-5
4.2.2 Switching Direct / Reverse Action ............................................................ 4-6
4.2.3 Setting Cycle Time (Control Output Renewal Period) ............................... 4-8
4.3 Setting Target Setpoint (SP) ................................................................................... 4-9
4.3.1 Setting Target Setpoint (SP) of UT130 ..................................................... 4-9
4.3.2 Setting Target Setpoint (SP) of UT150/UT152/UT155 ............................ 4-10
4.4 Setting Alarms ...................................................................................................... 4-12
4.4.1 Setting Alarm Type and Hysteresis ........................................................ 4-12
4.4.2 Setting Alarm Setpoint ........................................................................... 4-16
4.4.3 Heater Disconnection Alarm Function ................................................... 4-17
To Next Page
Loading...
Need help?
General
