< 3. INSTALLATION, PIPING AND WIRING >
3-1
IM 12A0V2-E
3. INSTALLATION, PIPING, AND WIRING
3.1 Unpacking
The ST401G sampling system is suffi ciently packed for shipment to prevent damage during
transportation.
Unpack carefully near the place of installation.
3.2 Installation place
Install the ST401G sampling system at a location as below:
(1) Free from rain water such as indoor or in a cubicle
(2) Low vibration
(3) Low corrosive gas
(4) Low humidity
(5) Low temperature variation and the temperature is maintained at or as near to room temperature
as possible
(6) Suffi cient maintenance space and easy maintenance access
3.3 Installation
Install the sampling system on a well-drained concrete foundation or the equivalent with anchor bolts
(M12). Refer to external dimensions (Figure 3.1 to 3.32) for the position of the anchor bolts.
Keep suffi cient maintenance space around the sampling system.
To Next Page
Loading...
