To Next PageTo Next Page
Need help?Do you have a question about the YOKOGAWA VY Series and is the answer not in the manual?
General| Type | Digital Multimeter |
|---|---|
| Display | LCD |
| Data Hold | Yes |
| AC Current Ranges | 400μA, 4000μA, 40mA, 400mA, 4A, 10A |
| Resistance Ranges | 400Ω, 4kΩ, 40kΩ, 400kΩ, 4MΩ, 40MΩ |
| Continuity Test | Yes |
| Diode Test | Yes |
| Auto Power Off | Yes |
| Input Impedance | 10MΩ |
| Display Digits | 4000 counts |
| Operating Temperature | 0°C to 40°C |
| Accuracy | ±(0.5% rdg + 3 dgt), AC Voltage: ±(1.5% rdg + 5 dgt), DC Current: ±(1.0% rdg + 3 dgt), AC Current: ±(2.0% rdg + 5 dgt), Resistance: ±(0.8% rdg + 3 dgt) |
Essential safety precautions for personnel and equipment during installation and operation.
Details on the product warranty terms, coverage, and exclusions.
Verifying the instrument's model number and specifications against the nameplate.
Guidelines for safely transporting and storing the flowmeter to prevent damage.
General precautions for installing the flowmeter considering ambient, atmospheric, and mechanical conditions.
Detailed guidelines on pipe straight lengths, orientation, and connections for accurate measurement.
Steps and considerations for physically mounting the flowmeter onto the piping system.
Specifies load resistance and wiring requirements for analog and digital outputs.
Procedures for connecting and preparing the vortex flowmeter signal cable (VY1C).
Best practices for wiring, including noise reduction, waterproofing, and proper grounding.
How to configure and understand the flowmeter's indicator displays and icons.
Overview of internal parameters and their default settings.
Explains system alarms, process alarms, setting alarms, and warnings with troubleshooting steps.
Procedures for zero adjustment, span adjustment, and loop testing for accurate measurement.
Managing totalizers, configuring pulse output, and setting burnout/write protect switches.
Adjusting low cut and performing zero tuning in manual mode for precise readings.
Troubleshooting guide for large or unstable output errors based on diagnostic checks.
Diagnosing and resolving cases where the indication drops to zero or shows zero during flow.
Troubleshooting steps for when the device indicates flow when no fluid is present.
Troubleshooting steps for errors related to the built-in temperature sensor.
Requirements and cautions related to the Pressure Equipment Directive (PED).
