6.3 Self-Diagnostic (Error Code List)
6.3.1 Errors and Countermeasures
■ System Alarms
The device has malfunctioned and normal measurement is not possible. The product might need to be
replaced.
NE107
Status
Error messages
Details of error Countermeasures
Indicator HART
F AL-010 010:CPU failure
A failure in the program memory of the transmitter
CPU is detected
Contact your nearest sales oce or Service Center.
F AL-011 011:CPU failure
A failure in the I/O calculation memory of the
transmitter CPU is detected
Contact your nearest sales oce or Service Center.
F AL-012 012:Main storage failure
Physical/logical failure of the transmitter EEPROM
is detected
Contact your nearest sales oce or Service Center.
F AL-013 013:Sub storage failure
Physical/logical failure of the sensor EEPROM is
detected
Contact your nearest sales oce or Service Center.
F AL-014 014:Main ASIC failure Operation stop of the main control IC is detected Contact your nearest sales oce or Service Center.
F AL-015 015:Sub ASIC failure Operation stop of the sub control IC is detected Contact your nearest sales oce or Service Center.
F AL-016 016:ADC circuit failure Failure of the sensor ADC circuit is detected Contact your nearest sales oce or Service Center.
F AL-017 017:Signal circuit failure Failure of the sensor signal circuit is detected Contact your nearest sales oce or Service Center.
F AL-018 018:Power circuit failure Failure of the sensor power circuit is detected Contact your nearest sales oce or Service Center.
F AL-020 020:Flow sensor failure Failure of the ow sensors (A or B) is detected Contact your nearest sales oce or Service Center.
F AL-021 021:Temperature sensor failure Failure of the temperature sensor is detected Contact your nearest sales oce or Service Center.
F AL-023 023:Analog input failure Failure of analog input device is detected Check the connections to the analog input device
<6. Parameters>
34
IM 01F07A01-01EN
To Next Page
Loading...
Need help?
General
