YOKOGAWA WT130 User Manual

IM 253401-01E
App2-27
App
Appendix 2.3 Commands
Communication Commands 2
2.3.10 RECall Group
The commands in the RECall group are used to make settings relating to, and inquires about recalling data. This allows you to
make the same settings and inquiries as can be set using the lower menus of [MEMORY]-”rECAL” or [MEMORY]-”PnLrC”.
:RECall : STAT e <Space> OFF
ON
<NRf>
?
INTer val <Space> <NRf> , <NRf> , <NRf>
?
PANel <Space> <NRf>
?
<Character string>
;
RECall?
Function Queries all the settings relating to recalling data.
Syntax RECall?
Example RECALL? → :RECALL:STATE 0;INTERVAL 0,0,0
RECall:INTerval
Function Sets the recalling interval/queries the current setting.
Syntax RECall:INTerval {<NRf>,<NRf>,<NRf>|<String>}
RECall:INTerval?
{<NRf>,<NRf>,<NRf>}=0,0,0 to 99,59,59
{<String>}=HH:MM:SS HH hour MM minutes SS
seconds
Example RECALL:INTERVAL 0,0,0
RECALL:INTERVAL “00:00:00“
RECALL:INTERVAL?
→ :RECALL:INTERVAL 0,0,0
Description Even when the interval has been set to 0,0,0, the
interval becomes 250ms in case of normal
measurement and 1s in case of harmonic analysis.
RECall:PANel
Function Retrieves the set-up parameters file.
Syntax RECall:PANel {<NRf>}
{<NRf>}=1 to 4 : file number
Example RECALL:PANEL 1
RECall[:STATe]
Function Turns recalling ON/OFF, queries the current setting.
Syntax RECall[:STATe] {<Boolean>}
RECall:STATe?
Example RECALL:STATE ON
RECALL:STATE? → :RECALL:STATE 1

YOKOGAWA WT130 Specifications

General

Brand	YOKOGAWA
Model	WT130
Category	Measuring Instruments
Language	English