5.3 Walk boost mode
Long Press and hold , the electric bicycle enters the walk boost mode. The electric bicycle will walk at a fixed speed
of 6 km per hour and the display shows . Release the button to stop the power output immediately and restore to the
state before walk boost.
Figure 5-2 Helping to implement the display screen
The walk boost mode can only be used when pushing the electric bicycle, please do not use it while riding.
5.4 Turning on/off lights
Press the to make the controller turn on the lights and the display backlight becomes dim. Press again to make
the controller turn off the lights and the backlight restore brightness.
Figure 5-3 B
acklight display interface
5.5 PAS level selection
Press / to switch PAS level of electric bicycle, thus changing the motor output power.
To Next Page
Loading...
