EN
Transceiver must be fixed on the camera for testing and
triggering. Make sure all the transceivers are fixed well, the
flash must be set to Manual mode.
1. Press the shutter release button halfway of the camera
to focus, the flash will be awaken if the flash is on the
status of sleep, awakening indicator light of transceivers
will turn on(green) in same channel.
2. In the state of awakening indicator on, press the shutter
release button completely of the transceiver which
installed on the hot shoe of the camera to testing flash
trigger, the off-camera flash will be triggering once.
3. After focusing, press the shutter release button
completely of the camera to shoot with flash trigger
synchronously, and the flash trigger indicator will turn
on (red) of transceivers at the same time.
● If the flash can not be awaked , please turn off the
power saving mode of the flash.
7
Wireless flash trigger & testing
To Next Page
Loading...
Need help?
General
