EN
1. Install the handhold flash on the hot shoe of the transceiver as transmitter.
2. Fixed the camera such as a tripod, installed the other transceiver on the hot
shoe of the camera as receiver,and connected with specially shutter cable to the
external shutter socket of the camera.
3. Press the shutter release button of the transceiver on flash for remote shooting,
and the flash will be triggering synchronously.
10
Handhold the flash for remote flash trigger sync
Take the RF-603 on flash light as shutter release remote control,additional YongNuo
2.5mm shutter connecting cable needs to be purchased.
● The function is available for single
frame shooting mode only.
● If the camera failed to focus, it may
take no photograph even signal
receiving, adjust the focus mode to
"M" (manual) for the lens.
Function extend
To Next Page
Loading...
Need help?
General
