4.Transmitter group setting
Method 1:
1).Half press the camera button to
enter into the transmitting state.
2).Short press the [GP/MODE] button
in the transmit state, set the
t r a n s m i t t i n g g r o u p , t h e n t h e
indicator light will display the
groups involved in flash.
Method 2:
Hold down the [TEST/-]
button in standby state,
an d s hor t p res s t he
[GP/MODE] button to
set.
5.Set the transmitter flash mode*
Long press the [GP/MODE] button until
the indicator light switch between green
(i-TTL flash) or orange (manual flash).
* Remote control mode only
To Next Page
Loading...
