15
3.Set the flash mode and parameter on the master
unit of each group (refer to the manufacturer's
usermanual ). It will communicate via the YN-
622N II transceiver's channel.
4.Use the test button of the transmitter to test flash and
shoot, the flash fires.
※The master unit set on the on-top of the transmitter
will not transmit infrared commands.
1.Turn on the master unit
and set to MASTER
(commander mode), then
turn on the transmitter.
2.Set the receiver group,
turn on the flash(Do not
set to remote), and set to
i-TTL flash mode.
Usage
3.Master Control Mode& On-top flash.
1.Power on of the on-top flash: First turn on the on-
top flash, then turn on the transmitter.
2.The on-top flash use non master control model:
Flash modes, exposure compensation (flash output),
zoom or other parameters set directly on the flash, not
affected by the transmitter settings. Supports i-TTL,
Manual, Repeating flash.
3.The on-top flash use master control mode:
Using the on-top flash(master unit) which support
master mode to set each group of flash mode and
parameters, support i-TTL, Manual flash.
To Next Page
Loading...
Need help?
General
