17
Reference-About 603-RX
1.Set to the 603-RX mode through the power switch.
2.Set the same channel as the transmitter (Shortly
press the [ ]button).
4.Set the flash in manual mode, adjust the flash
output, shoot and trigger the flash.
Supports grouping function of the YN560-TX、
RF605.
When the power switch set to “603-RX”, it is
recommended only use the YN560-TX/RF603/RF605
as transmitter, the YN622N II as receiver. If it is used
as transmitter in this communication mode, it will
transmit as “622” communication mode.
3.Set the receiving group (press the【GP/MODE】button).
The YN622N II supports receiving the triggering signal
YN560-TX (RF603 communication mode), meanwhile
supports the triggering signal(the flash set to M mode) of
the RF603(II)、RF605(RF603 communication mode).
To Next Page
Loading...
