Thank you for purchase the products of Yongnuo firstly.
The new upgrade version YN622N II can set to "622" or "603-
RX" communication mode through the power switch,
supports receiving the trigger signal of the YN560-
TX/RF605(603 mode)/RF603(II) series products, with multi
aspects improved, equipped with quick lock design and
supports USB firmware upgrade.
YN622NII i-TTL wireless transceiver is a high performance
2.4G wireless flash trigger designed for Nikon users. Different
photographic effects can be realized through setting the flash
at 360 degrees. It supports i-TTL and manual flash, front-
curtain sync, rear- curtain sync and high-speed sync(Auto FP),
the highest sync speed is 1/8000s*. it can remote change flash
exposure compensation or flash output of each group,
supports different flash mode mix using. Supports the
transmitter installed i-TTL flash, in addition, it supports the
master unit on transmitter sets the parameters of each group.
This product is a wireless transceiver design, the distance of
remote control reaches 100M, supporting 7 wireless channels
and A/B/C three groups, and with AF assist beam emitter
function.
YN622N 2 transceivers kit consist two similar transceivers,
support one camera controlling multiple flashes at the same
time. Install the flashes with the receiver additionally purchased
to make them into an application form of multiple-flashes,
number of the receivers is not limited.
※ Compatible cameras/flashes is needed when using TTL
function
※ The highest sync speed of some camera types is 1/4000s,
some of flash or camera models may reach to 1/250s only
or less if it doesn't support high sync speed.
Function Introduction
2
To Next Page
Loading...
Need help?
General
