EasyManuals Logo

Yongnuo YN-622N User Manual

Yongnuo YN-622N
22 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #9 background imageLoading...
Page #9 background image
7
3.Install Flash on the Hot Shoe of the Receiver
1. Install the transceiver on the mini
stand or other fixing equipment
(excluded).
2. Loosen the locking ring of the flash.
3. Slip the mounting foot of the flash
into the receiver.
4. Tightly lock the locking device of
the flash.
Ca u ti on ! Th e ho t sh ot of the
transceivers can only install flash
being applicable to DSLR cameras,
can not install high-voltage flash,
or the transceiver may be damaged.
Preparation Before Use
Che c k t h at al l e quip m e n t s ar e i nsta l l e d an d
connected reliably before use, turn all equipments on,
setting the transceivers in the same channel, set the
group of receivers, set the control mode according to
your requirement, setting the flash mode before using,
test button can be used to awaken and test whether the
flash works before shooting, press the shutter button
until the flash recyling completely, and flash fire.
4.Sets the Flash Mode according to the Control Mode
1).Remote Control Mode: refer to p14.
2).Mix Control Mode: refer to p14.
3).Master Control Mode(Master input): refer to p15.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Yongnuo YN-622N and is the answer not in the manual?

Yongnuo YN-622N Specifications

General IconGeneral
BrandYongnuo
ModelYN-622N
CategoryTransceiver
LanguageEnglish

Related product manuals