13
When half press the shutter button of the camera,
the hot-shoe flash will be awaken.
In standby state, pressing the [TEST/-] button of the
transceiver will awake the flash. When loosening the
button, the flash of the group having been selected will
fire a test flash.
In transmitting state, short press the [TEST/-] button
will fire a test flash.
Refer to the following figure, the transmitter sets
A+B two groups of flash , hold down the [Test/-] button,
the flash on A and B of the receiver will be awakened,
and when loosening [TEST/-] button will fire a test flash.
※ If the flash can not be awakened, manually
awaken the flash before shooting.
※ Using PC port to connect with flash without the
awakening function.
※ A l l t he i n d i ca t or s g o in g o ut w he n f l a sh
fires(Receiver).
Flash awaking and testing flash
To Next Page
Loading...
