12
Enable/disable (stand by)
7.Flash Shutter Sync:
AUTO FP
Refer to the camera’s setting. Supports front-curtain
sync, rear-cur tain sync and high speed synchronous
(HSS/Auto FP*).
*Using high-speed synchronization need to set the flash
sync speed of the camera to .
*The maximum high-speed synchronization speed is
1/8000s or 1/4000s (depends on the camera).
*Some models of camera does not support the HSS
(without Auto FP option), the shutter speed will be
limited to 1/250s or less when using this kind of camera.
※ It need to using single AF of the camera.
※ Both the receiver and the off-camera flash on the
receiver will not be emitted.
Setting
8.AF Assist Beam Emitter
When using AF under low-light, the
built-in AF-assist beam emitter of the
t r a n s m i t t e r w i l l b e e m i t t e d
automatically to make it easier to
autofocus, and the on-top flash which
support AF assist beam emitter function
can also be emitted at the same time.
State
Operate
Channel
indicator
AF assist
beam emitter
On Enable
Off Disable
Press【 】button
more than 3 seconds
Blinking three times Enable/Disable
Press【 】button
less than 3 seconds
To Next Page
Loading...
