11
When the 622N using master contorl mode(refet to
p15) , the manual output values of the master unit and
manual output value of YN-622N convert as below:
Manual Flash Output Control(remote control mode)
YN-622N provides a general way of manual control
of the flash output . For the same manual flash output
values of 622N, even using different GN of the flash, the
output is the same (in case not exceed the effective
range of the flash).
The minimum manual flash output value of 622N is 1,
the maximum flash output according to different GN of
the flash, the default value is 8, add 1 step is 10.4, add 1
step is 16, and so on. The value of 622N is proportional,
when the value A is twice as B, the flash output of the
former is half of the latter, refer to the form below.
※ When setting the flash mode and parameters on the
transmitter, the screen of the flash on the receiver will not
change.
※ Re s t a r t t h e t r a ns m i t t er w i l l r e s t o r e t h e d e f a u l t
com p e n s at i o n o r t h e f l a s h o utp u t s e t t i ng . (i - T T L
compensation=0 /Value of Manual flash=8)
※ When the setting parameters reach the maximum or
minimum, the corresponding indicator will not blink.
Setting
1 1.3 1.7 2 2.6 3.4 4 5.2 6.8 8 10.4 13.6
16 20.8 27.2 32 41.6 54.4 64 83.2 108.8 128
MASTER 1/128 +0.3 +0.7 1/64 +0.3 +0.7 1/32 +0.3 +0.7 1/16 +0.3 +0.7
YN-622N 1 1.3 1.7 2 2.6 3.4 4 5.2 6.8 8 10.4 13.6
MASTER 1/8 +0.3 +0.7 1/4 +0.3 +0.7 1/2 +0.3 +0.7 1/1
YN-622N 16 20.8 27.2 32 41.6 54.4 64 83.2 108.8 128
To Next Page
Loading...
Need help?
General
