A-Set the controller SS time delay parameters in C.FN 01:
(refer to Page 14)
B-Using Super Sync:
1).Set the flash into manual mode. It supports to use the flash
which is set on the hot-shoe of the transceiver or connect the
flash through PC port. Setting full power flash output (1/1) may
be needed.
Adjust “SS” to a suitable time delay parameters according to
the flash model, output power and shutter speed.
2).Set the flash sync speed of the camera as high speed sync,
the maximum shutter sync speeds can reach to 1/8000s.
3).Take photos and check whether the flash of the photos is
synchronous. The gradations or variations of the light will be
seen in the photos. The flash result will be different due to
different cameras and flashes.
2. About the Automatic Save Function:
Then controller will automatically save the settings of channel,
grouping, flash mode, AF assist beam emitter etc.
1.
Use non-HSS (Non High Speed Sync) flash to realize High
Speed Sync. This function is more applicable to strobes
flashes whose flash duration is longer. It should be used with
cameras which supports High Speed Sync (HSS) and setting
SS time delay parameters.
About the Super Sync(SS)
Reference
To Next Page
Loading...
Need help?
General