Troubleshooting
1. Fail to power on or automatic shutdown:
The battery is loaded inversely or exhausted.
ØInstall the battery according to the correct direction the
battery compartment indicates and ensure the battery is full
and restart the power .
2. The flash doesn't fire
ØEnsure the power of all equipments are full, the flash is
in ready state(the flash-ready indicator on)
ØEnsure the connection among the controller(transceiver),
camera and the flash is reliable.
ØWhether the controller and transceivers are set in the
same channels and controllable groups.
3. TTL underexposure or overexposure:
Check whether the camera body or the flash sets
exposure compensation. It may be underexposed if exceeds
the effective flash distance. It may overexpose when TTL
and manual flash are used at the same time, at this time the
manual flash suits to be used as a backlight.
When other trouble occurs during using, it's suggested
to deal with the trouble with the procedures as below:
1). Restart all the equipments.
2). Replace the batteries of the controller and transceivers.
3). Reset the factory set of the controller and transceivers.
4).Reset the factory set of the camera/flash.
20
To Next Page
Loading...
Need help?
General