To Next PageTo Next PageTo Previous PageTo Previous Page
Need help?Do you have a question about the Yongnuo YN622C-TX E-TTL and is the answer not in the manual?
General| Brand | Yongnuo |
|---|---|
| Model | YN622C-TX E-TTL |
| Category | Network Router |
| Language | English |
Lists Canon EOS DSLR models compatible with the controller.
Explains icons used in the manual for button presses (short/long).
Details all buttons, ports, LCD, and indicators on the YN622C-TX controller.
Details components of the YN622C transceiver, including hot shoe and battery compartment.
Guides setting the channel and receiving group for the YN622C transceiver.
Instructions for installing batteries, mounting the controller, and setting the channel.
Explains how to switch between GR, TTL, and Multi flash modes using the MODE button.
Details setting flash modes for individual groups in GR mode.
Explains FEC adjustment in TTL mode and its interaction with flash settings.
Describes how to adjust flash output power and fine-tune settings in Manual mode.
Covers Super Sync settings and disabling flash groups.
Guides setting TTL flash groups and adjusting flash ratios or exposure compensation for groups.
Explains how to set output power, frequency, and count for stroboscopic flash.
Instructions for setting the flash zoom focal length for groups A/B/C.
Details how to set 1st curtain, 2nd curtain, and high-speed sync modes.
How to wake up the flash and test trigger functionality using the TEST button or camera shutter.
Explains how the camera shutter fully pressed triggers the flash synchronously.
Configuration range for Super Sync time delay adjustment.
Options to enable or disable the wireless shutter release feature.
Controls the AF assist beam emitter, with on-screen icon indication.
Setting for single-contact trigger function compatibility.
Enables compatibility with EX series flashes for manual control.
Using PC interface for triggering and basic single-contact triggering.
Using non-HSS flash for higher sync speeds, suitable for studio lights.
Controller automatically saves settings like channel, group, mode, and AF assist.
Remote manual flash control for non-menu-controlled flashes like 430ex.
LCD backlight activates for 5 seconds when any button is pressed.
Battery icon on LCD shows current power; blinks when low.
Restores controller settings to default by holding MODE and SYNC/FN buttons.
Steps to download and install firmware updates from the YONGNUO website.
Solutions for failure to power on or automatic shutdown due to battery issues.
Checks for sufficient battery, reliable connections, and correct channel/group settings.
Addresses over/underexposure in TTL mode, suggesting manual flash for backlighting.