Using the LED light
1.Make the flash unit vertical（90°upward bounce）
2.Press the [LED]button， the LED comes on, the LED lighting on the LCD
panel.
3.Rotate the [ ]to adjust the brightness.
4.Press the [LED] button again or press the function button[ ]to turning
off the LED light.
Using the bulit-in diffuser
Using a built-in diffuser reduces glare and
softens light. It can also unnatural multiple
shadows.
Firmly pull the handle of the built-in diffuser
down to the bottom of the window and attach it.
when storing, pull the handle up into the main
body.
Brightness:50%
LED Lighting:
Using the color conversion filter
Using a color conversion filter lets you change
the color temperature to about 3200K(at
maximum brightness)
Align the clips on each side of the color
conversion filter with the rim of the LED light and
press the color conversion fliter on.
To remove the color conversion fliter, hold the
protrusions on each side and pull it off.
The flash cannot fire when the LED light is on.
The color temperature varies slightly with brightness adjustments and
LED temperature, so check the white balance before recording.
create multiple shadows of the subject.
The LED light goes off when the flash head is directed horizontal or
downward.
Using this flash unit when the subject is too close to the camera may
Shooting with LED Light
Using the LED light with radio wireless master
When shoot with LED light, press the function button [MASTER] to keep
shooting with LED light and use(the master flash is disable).
-22-
To Next Page
Loading...
Need help?
Power
Flash Specifications
Weight and Dimensions
