Need help?Do you have a question about the York Eco 2 and is the answer not in the manual?
General| Brand | York |
|---|---|
| Model | Eco 2 |
| Category | Air Conditioner |
| Language | English |
Explanation of safety symbols used in the document to indicate potential hazards.
Setup for cooling control using a thermostat in CV units.
Setup for heating control using a thermostat in CV units.
Setup for cooling control via space sensor in CV units.
Setup for heating control via space sensor in CV units.
Setup for cooling control without external devices in CV units.
Setup for heating control without external devices in CV units.
Setup for cooling control using a thermostat in VAV units.
Setup for heating control using a thermostat in VAV units.
Setup for cooling control via space sensor in VAV units.
Setup for heating control via space sensor in VAV units.
Setup for cooling control without external devices in VAV units.
Setup for heating control without external devices in VAV units.
Configuration for Constant Volume units with Dry Bulb economizer.
Configuration for Constant Volume units with Single Enthalpy economizer.
Configuration for Constant Volume units with Dual Enthalpy economizer.
Configuration for VAV units with Dry Bulb economizer.
Configuration for VAV units with Single Enthalpy economizer.
Configuration for VAV units with Dual Enthalpy economizer.
Configuration for economizer loading capabilities.
Setup for integrating the unit with a Building Automation System.
Setting for fixed minimum ventilation rates.
Configuration for Demand Ventilation based on Indoor Air Quality.
Settings for comfort-based ventilation modes.
Managing excessive supply air temperature during cooling.
Managing excessive supply air temperature during heating.
Adjusting ventilation minimum position at low ambient temperatures.
Setup and operation of hydronic heating systems.
Configuration for the morning warm-up sequence.
Controlling exhaust fan based on outdoor damper position.
Controlling exhaust fan based on building pressure.
Modulating exhaust fan operation with fixed speed.
Modulating exhaust fan operation using a Variable Frequency Drive.
Setup for pre-occupancy purge cycle.
Disabling heating based on outdoor air temperature.
Configuration and function of the hot gas bypass.
Setting up alarms for space temperature deviations.
Setting up alarms for supply air temperature during heating.
Setting up alarms for supply air temperature during cooling.
Configuration for the Intelli-Start operation feature.
Adjusting setpoints using the space sensor.
Connecting and configuring remote control inputs.
Setup for the dirty filter switch and indicator.
Enabling and configuring the unit for metric measurements.
Description of the buttons and displays on the unit controller.
Explanation of how to use the Test/Up, Address/Down, and Alarm/Change buttons.
Reference for control function addresses and their settings.
Overview of the factory QA check and field test utility.
Steps to start the unit controller's run test sequence.
Detailed steps of the automated operational test sequence.
To Next Page
