OPTIONAL PARTS
TC-17005-rev.1
3-11
(3) While pushing the wiring into the corner,
insert two coupling hooks at
A
to the
square hole of the decorative panel, and
push the IR receiver kit in the direction
of the arrow (
A
) shown at the far right.
Then, insert the xing hook at
B
to the
square hole of the air panel.
NOTE:
Securely afx the coupling hooks of the IR
receiver kit to the decorative panel to avoid
damage to the xing hooks.
(4) Removing Corner Cover
The corner covers can be removed pulling
the
A
part toward the arrow direction.
8
After the installation work for the IR receiver kit is completed, attach the corner covers (three parts).
For details, refer to the Installation Manual for the decorative panel.
NOTE:
After the IR receiver kit is attached to the decorative panel, the one corner cover (attached with the
decorative panel) becomes unnecessary.
3.8.6 Optional Functions
Turn OFF the power supply completely before setting the DIP switch for the IR receiver kit.
Not turning off the power may cause an electric shock.
1
The following switches are on the IR receiver kit.
Coupling Hook
A
B
B
A
A
EMERGENCY
COOLHEAT
RUNFILTER DEFTIMER
"COOL" Button"HEAT" Button
PCB
Rear Side of IR Receiver Kit
Cover
Remove
the screw
DIP Switch (DSW1)
(Factory-Setting)
123456
ON
To Next Page
Loading...
