Mat alignment and tension
The alignment and tension of the mat (walking surface) has
been set prior to shipping. Should improper tracking of the
mat occur (walking surface moving too far to right/ left on the
platform) or if you nd that the mat slips when you get on,
these problems can be corrected as follows:
Locate the adjustment screws on the end of the main
frame. CAUTION: Adjust the mat when the treadmill is
running at low speed. Keep others away from the treadmill.
Connect the safety key and set to the lowest speed.
Allow the mat to run for several minutes and watch to see if it runs in the center position properly. If the mat does not run
in the center position, carry out the steps for “MAT MOVES TO LEFT” or “MAT MOVES TO RIGHT”. Be sure that you adjust by
“1/2 turn only each time” to avoid over correcting.
MAT MOVES TO RIGHT: If your mat tends to move to the right, then adjust the right screw by turning it a 1/2 turn clockwise.
We recommend adjustments of 1/2 turn only at a time, then test each time. If your mat continues to move to the right, simply
adjust the left adjustment screw, by turning 1/2 turn counterclockwise, test after each adjustment.
MAT MOVES TO LEFT: If your mat tends to move to the left, then the adjustment of the right screw is necessary by turning
counterclockwise. We recommend adjustments of 1/2 turn only at a time, then test each time. If the mat continues to move to
the left, simply adjust the left adjustment screw, by turning 1/2 turn clockwise, then test each time.
NOTE: For most people, one of your legs is stronger than the other and the treadmill mat may tend to track to that side
because of the extra pressure exerted by your stronger leg. If this occurs then either dismount the treadmill and allow
the mat to track back to the middle, or exert pressure to the side of the mat with the other leg to track the mat back to
the middle. Or adjust the mat to compensate following the instructions for the mat moves to the right or left.
MAT TOO LOOSE: If your mat appears to be loose, simply tighten both screws by an equal amount (1/2 a turn clockwise at a
time) then test.
MAT TOO TIGHT: If it appears tight, simply loosen both screws by an equal amount (1/2 a turn counter-clockwise at a time)
then test.
MAT STICKY (DOES NOT RUN SMOOTHLY): You may feel after a period of time (depending on how often you use the
machine) that the mat feels sticky. We recommend you apply a light covering of Silicone between the mat and the running
board. This procedure may be repeated as necessary.
Mat and deck lubrication
This treadmill is equipped with a pre-lubricated, maintenance deck system. The mat / deck friction may play a major role in the
function and life of your treadmill, this requires periodic lubrication. We recommend a periodic inspection of the deck. If the
deck appears worn, please contact our service department.
We recommend lubrication of the deck according to the following timetable:
Less than 3 hours per week - every 8 months.
3-5 hours per week - every 4 months
More than 5 hours per week - every 2 months.
Proper Lubrication Application
Using a coin to open the top cap covers above the left and right lubricant bottles. Then put half of lubrication that is in the
spare parts box into the left and right bottles. After it is done, put the top cap covers back and tighten them securely.
Start the treadmill and set the speed at the lowest speed. Let the mat run for about 15 minutes in order to spread the
lubrication on the underneath side of the running mat properly.
1.
2.
3.
•
•
•
MAT ADJUSTMENT BOLTS
USE ALLEN KEY TO ADJUST MAT
AS INSTRUCTED BELOW.
OPERATING INSTRUCTIONS
To Next Page
Loading...
