York Solution - Disassembly - Coil Bulkhead and Raceways; Remove Coil Bulkhead and Bottom Raceways

YORK INTERNATIONAL
14
FORM 102.20-FA1 (1104)
b) Slide coil onto forklift or cribbing.
c) Carefully guide coil away from bulkheads and
raceways.
d) Set coil on four” x four” blocking.
FIG. 19 - MOVING COIL
FIG. 20 - BLOCK COIL
19 – REMOVE COIL BULKHEAD
FIG. 21 - REMOVE COIL BULKHEAD
Do not remove drain pan unless
necessary to fi t through entranceway.
A positive water/air seal is extremely
diffi cult in the fi eld.
20. REMOVE BOTTOM TIER RACEWAYS
a) Remove 3/16" hex allen head screws from bot-
tom of vertical raceways.
FIG. 22 - REMOVE 3/16" HEX ALLEN SCREWS
b) Separate raceway assembly from base and set
aside.