York SUNLINE ULTRA D1HG 060 User Manual

CONTENTS
GENERAL ....................................3
INSPECTION . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3
REFERENCE..................................3
APPROVALS . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3
LIMITATIONS..................................4
UNIT APPLICATIONS DATA . . . . . . . . . . . . . . . . . . . . . . 4
LOCATION....................................4
RIGGINGANDHANDLING .......................4
CLEARANCES.................................5
DUCTWORK . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5
FILTERS .....................................5
CONDENSATEDRAIN ..........................5
THERMOSTAT ................................6
POWERANDCONTROLWIRING .................6
COMPRESSORS...............................6
OPTIONALECONOMIZERRAINHOOD ............7
DISCONNECTSWITCHBRACKET ................9
COOLING SYSTEM . . . . . . . . . . . . . . . . . . . . . . . . . . . . 15
PRELIMINARYOPERATIONCOOLING............15
COOLINGSEQUENCEOFOPERATION ...........15
SAFETYCONTROLS ..........................15
HEATING SEQUENCE OF OPERATION . . . . . . . . . . . 15
TWO-STAGEHEATING: ........................16
HEATANTICIPATORSETPOINTS................16
BELT-DRIVEBLOWER .........................16
NORMALMAINTENANCE.......................17
INSTALLATION
INSTRUCTION
CAUTION: READ ALL SAFETY GUIDES BEFORE YOU
START TO INSTALL YOUR FURNACE.
SAVE THIS MANUAL
SUNLINE ULTRA
TM
GAS / ELECTRIC SINGLE
PACKAGE AIR CONDITIONERS
MODELS: D1HG 036, 048 & 060
(12-13 SEER)
035-14841-000 Rev. A (0701)

York SUNLINE ULTRA D1HG 060 Specifications

General

Tonnage	5 Tons
Cooling Capacity	60, 000 BTU/h
Heating Capacity	60, 000 BTU/h
Refrigerant	R-410A
Indoor Unit Noise Level	52 dB(A)
Power Supply	208-230V, 60 Hz

Summary

General Unit Information

Unit Inspection Procedures

Instructions for inspecting the unit upon receipt for damage.

Unit Specifications and Location

Selecting the Unit Location

Guidelines for selecting a suitable outdoor installation location for the unit.

Rigging and Handling the Unit

Procedures and precautions for safely lifting and moving the unit.

Unit Installation Details

Required Clearances for Operation

Required clearances for proper unit operation and service access.

Ductwork Design and Sizing

Electrical and Accessory Installation

Thermostat Installation Guidelines

Power and Control Wiring Requirements

Conformance requirements for electrical wiring and grounding.

Compressor Mounting Bolt Release

Unit Dimensions and Wiring Diagrams

Unit Dimensions and Clearances Diagram

Typical Power Wiring Diagram

Diagram illustrating typical unit power wiring connections.

Typical Control Wiring Diagrams

Diagrams for typical thermostat and unit control wiring.

Performance and Electrical Data

Supply Air Performance - 3-Ton Units

Supply Air Performance - 4-Ton Units

Supply Air Performance - 5-Ton Units

Static Resistances Table

Belt-Drive Blower Motor Data

Basic Unit Electrical Data

Electrical specifications including voltage, ampacity, and fuse/breaker sizes.

Unit Operation and Safety

Cooling System Overview

Preliminary Cooling Operation Steps

Cooling Sequence of Operation

Refrigerant System Safety Controls

Details on the refrigerant system's safety controls and their function.

Heating Sequence of Operation

Sequence of operation for single and two-stage heating modes.

Maintenance and Owner Approval

Unit Maintenance Procedures

General overview of required maintenance procedures.

Normal Maintenance Tasks

Specific tasks for filters, motors, and outdoor coil cleaning.