JOHNSON CONTROLS
FORM 150.67-EG1 (219)
46
Unit Dimensions (Cont'd)
YCAL0028
LD18673
NOTE:
Placement on a level surface of free of obstructions (including snow, for winter operation) or air circulation ensures rated performance, reli-
able operation, and ease of maintenance. Site restrictions may compromise minimum clearances indicated below, resulting in unpredictable
airow patterns and possible diminished performance. Johnson Controls’s unit controls will optimize operation without nuisance high-pressure
safety cut-outs; however, the system designer must consider potential performance degradation. Access to the unit control center assumes
the unit is no higher than on spring isolators. Recommended minimum clearances: Side to wall – 6'; rear to wall – 6'; control panel to end
wall – 4'0''; top – no obstructions allowed; distance between adjacent units – 10'. No more than one adjacent wall may be higher than the
unit.
To Next Page
Loading...
