Antivibration supports
Whenever necessary to reduce vibrations and noise
produced by the unit to the maximum, a set of rubber
antivibration supports can be used. These should be
installed between the chassis support of the unit and
the base or floor on which it is to sit.
This base must be solid and dimensioned in accord‐
ance with the load to be supported.
Use 8/10MA bolts to fasten the supports to the base
of the chassis.
The antivibration support accessory includes 4 parts.
These spring supports should be distributed and fas‐
tened in the drilled holes at the base of the cooling
unit, the location of which is detailed in the section
Dimensions, clearance and accesses of the docu‐
ments
Installation
and
Technical Information
for the
unit.
To Next Page
Loading...
