51
Line 1 Terminal version
Line 2 Control version
Line 3 Control monitoring direction
Line 4 Error percentage between terminal and control unit
Installation
No configuration is necessary for the remote terminal to be
operative as it operates independent of the control serial
direction (can be selected by means of parameter H10).
When starting up, the display will show the control version.
After 4 seconds, all symbols are displayed. Should the RS485
connection be incorrect, or if the control unit is off, offline will
appear on screen.
Info mode
Pressing the UP, DOWN and SEL keys simultaneously for
over 6 seconds displays on screen four line with system
information and its communication.
To Next Page
Loading...
