To Next PageTo Next Page
Need help?Do you have a question about the York YMAA 0065 and is the answer not in the manual?
General| Model Number | YMAA0065 |
|---|---|
| Tonnage | 5.5 tons |
| Refrigerant | R-410A |
| Cooling Capacity | 65000 BTU/h |
| Heating Capacity | 68000 BTU/h |
| Power Supply | 208-230V, 1-phase, 60Hz |
Outlines the safety standards and codes the units comply with.
Highlights potential hazards and damages from improper unit operation.
Describes the procedure for emergency unit shutdown via the control panel.
Lists essential checks to be completed before unit operation.
Specifies site selection criteria and required clearances for proper operation.
Details the requirements for connecting the chilled liquid piping system.
Covers general wiring requirements and recommendations.
Describes the emergency stop button for immediate shutdown.
Details the electrical power supply connections for single units.
Specifies the operating limits for temperature and flow rates.
Outlines the absolute voltage limits to prevent compressor damage.
Lists physical dimensions, weights, and capacities of the units.
Provides detailed electrical specifications for various unit configurations.
Presents the overall electrical wiring diagram for the unit.
Explains how to configure unit settings using DIP switches.
A comprehensive checklist for initial unit start-up.
Pre-start checks before applying power to the unit.
Procedures for verifying superheat and subcooling levels.
Explains how to access, read, and reset unit and system faults.
Explains how the unit manages its cooling or heating load.
Explains how the unit regulates leaving or return liquid temperatures.
Details the logic for staging compressors based on run time and load.
Explains the system for removing frost from ambient coils.
Provides a guide to diagnosing and resolving common unit problems.
Explains fault codes and their corresponding BACnet object names and classes.
Explains the fault codes specific to the Variable Speed Drive.
