Need help?Do you have a question about the York YMGE36BNO-MS-X and is the answer not in the manual?
General| Tonnage | 3 Ton |
|---|---|
| SEER | 18 |
| HSPF | Up to 9.5 |
| Cooling Capacity | 36000 BTU/h |
| Heating Capacity | 36000 BTU/h |
| SEER Rating | 18 |
| HSPF Rating | 9.5 |
| Refrigerant Type | R-410A |
| Voltage | 208/230 V |
| Phase | 1 |
Key inspection points and general information for the YORK unit before operation.
Covers critical safety warnings, electrical hazards, and proper disposal procedures for the unit.
Essential recommendations for unit placement, service clearance, and outdoor coil air supply.
Step-by-step guide for installing the YORK unit on a rooftop structure.
Instructions for correctly installing the YORK unit on a ground-level pad.
Proper foundation gradient and condensate drain piping connection for the YORK unit.
Guidelines for insulating, weatherproofing, and connecting ductwork to the YORK unit.
Details on electrical power availability, disconnect switch, and over-current protection for the unit.
Instructions for installing power wiring, control wiring, and ensuring secure connections.
Essential checks for unit placement, ductwork, wiring, grounding, and components before start-up.
Step-by-step guide to start the YORK unit in cooling mode using the thermostat.
Verifying voltage, performing cooling shutdown, and maintaining compressor heater power.
Understanding LED displays, fault codes, and indicators of proper system operation.
Explanation of low and high-pressure switch operations and their role in compressor protection.
Details on temperature sensors (T3, T4) and system response to sensor failures.
To Next Page
