Need help?Do you have a question about the YSI Professional Plus and is the answer not in the manual?
General| ORP Range | -999 to +999 mV |
|---|---|
| ORP Accuracy | ±1 mV |
| Data Logging | Yes |
| Waterproof | Yes |
| IP Rating | IP67 |
| Category | Water Quality Meter |
| Measurement Parameters | pH, ORP, Conductivity, Salinity, Dissolved Oxygen, Temperature, Turbidity |
| pH Range | 0 to 14 |
| Conductivity Accuracy | ±0.5% of reading |
| Dissolved Oxygen Range | 0 to 50 mg/L |
| Temperature Range | -5 to 55°C |
| Display | LCD |
| Turbidity Range | 0 to 1000 NTU |
| Salinity Range | 0 to 70 PSU |
| Accuracy | See individual parameter accuracies |
Unpack and inspect instrument and accessories for damage.
Instructions for installing two C-cell batteries into the instrument.
Lists compatible cable numbers and available sensors.
Covers installation of common sensors onto a Pro Series cable bulkhead.
Shows sensor placement in dual and Quatro cable ports.
Instructions for sealing unused ports to maintain water protection.
Specific instructions for installing the C/T sensor in a Quatro cable.
Set the instrument's date and time format and values.
Set password protection for calibration menu access.
Select the display language for the instrument.
Configure data logging, including site/folder lists and continuous mode.
View instrument software version and serial number.
Identify instruments in Data Manager software and GLP files.
Set temperature units and display options.
Detailed procedure for 1-point and 2-point DO% calibration.
Guide for calibrating DO in mg/L or ppm using a titration method.
Configure ISE sensors for Ammonium, Nitrate, or Chloride measurement.
Specific instructions for measuring dissolved oxygen.
Instructions for obtaining accurate conductivity readings.
Information on available data memory and freeing it up.
How to access and filter logged data.
Explains common error messages and their causes.
To Next Page
