Need help?Do you have a question about the YSI ProDIGITAL and is the answer not in the manual?
General| Model | ProDIGITAL |
|---|---|
| Display | LCD |
| Connectivity | USB |
| Data Logging | Yes |
| Category | Water Quality Meter |
| Measurement Parameters | Dissolved Oxygen (DO), Temperature |
| Power Supply | Rechargeable battery |
| Operating Temperature Range | 0°C to 50°C |
| Waterproof | Yes (IP67) |
| Measurement Range (O2) | 0 to 50 mg/L |
| Resolution (O2) | 0.01 mg/L |
| Salinity Range | 0 to 70 PSU |
| Response Time | Less than 30 seconds |
| Operating Conditions | 0 to 50°C |
Information on the battery pack's lifespan and factors affecting it.
Procedures for installing and removing sensors from the ProDSS 4-port cable.
Details on using the instrument's keypad and navigating menus.
How to adjust instrument settings like date, time, language, and display.
Configuration options for connected sensors, including setup and calibration.
Step-by-step guide on how to calibrate and take accurate measurements.
Preparing the instrument and calibration cup for sensor calibration.
Steps for calibrating the conductivity sensor using appropriate standards.
Detailed procedures for 1, 2, and 3-point pH and ORP sensor calibration.
Calibration procedures for Ion-Selective Electrode (ISE) sensors like Ammonium, Nitrate, Chloride.
Cleaning and storage guidelines for the main handheld unit.
Procedures for cleaning and maintaining various sensors (Depth, Temp, Cond, DO, Turbidity, pH/ORP, ISE).
Instructions for replacing the Optical Dissolved Oxygen sensor cap.
Guide to installing the KorDSS software and necessary drivers on a PC.
Critical safety warnings and precautions for handling lithium-ion batteries.
Details about the product warranty, coverage, and limitations.
Table of DO% calibration values correlated with pressure readings.
Table showing oxygen solubility in water based on temperature and salinity.
To Next Page
