YSI ProDIGITAL - Calibration Menu

25
Operation
2.7
Calibration Menu
6
7
5
4
2
3
1
Push the Calibrate (
Cal
) key to access the Calibration menu (Figure 36). Highlight a sub-menu then push the
ENTER
key to view sub-menu options. Pre-defined or user-selected parameters are noted within brackets ( [ ] ). Refer to the
Calibration section for sensor specific calibration procedures.
NOTE: User ID, Probe ID, and User Field #1 and #2 can be enabled in the Calibration Settings under the
System menu.
Figure 36 Calibration menu
1 Sensors connected 5 User ID
2 Optional Depth sensor calibration 6 Probe ID
3 Barometer calibration 7 User Field #1
4 Restore Default Calibration - restores
specified sensor to factory default