YSI ProDIGITAL - Installing the Driver and Software

63
KorDSS Software Installation
Figure 82 KorDSS Installer
Figure 83 ProDSS Driver Installer
Figure 84 Back button
Figure 85 KorDSS license agreement
Figure 86 Launch KorDSS
5.2
Installing the Driver and Software
Follow these steps to complete the installation process and establish
connection to the handheld:
NOTE: Be sure to install the driver before connecting the handheld
to your PC for the first time.
1. Insert the supplied USB flash drive into a USB port on your
computer.
2. Depending on the PC operating system and system settings, the
KorDSS Installer may appear. If it does not appear, open the flash
drive in Windows Explorer and double-click Start.exe to start
the installer. Figure 82 shows how the installer will appear once it
starts.
3. On the KorDSS Installer, click Install Driver. Then choose to Install
the driver on the screens that follow (Figure 83).
4. After the driver has installed, choose to go Back to the KorDSS
Installer (Figure 84) .
5. On the KorDSS Installer, click Install KorDSS Application. A
license agreement will appear (Figure 85).
6. You may be asked if you want to allow a program from an
unknown publisher to make changes on the computer. If so, select
Yes.
7. After successful installation of KorDSS, click Launch to start the
program (Figure 86).
8. Connect the handheld meter to the PC with the supplied USB
cable.
9. Power on the handheld and click Connect when it appears under
the Instrument Connection Panel; there may be a short delay
before it appears in the software.