6
Introduction
The cable connectors are keyed for positive mating and to prevent connector damage (Figure 3). The handheld retains
its IP-67 waterproof rating when the cable is disconnected. However, the connectors are not wet-mateable and should
be clean and dry before connecting.
Align the keys on the cable connector with the slots on the handheld connector. Push together firmly, then twist the
outer ring clockwise until it locks into place.
Figure 3 Keyed connectors
1 Handheld female connector 3 Keyed area of connector
2 Slotted area of connector 4 Cable male connector
1.4
Connect the Handheld to the Cable
Assembly
1
2
4
3
To Next Page
Loading...
