Auxiliary measuring function
If the cuff winded properly, it will show the '' '' icon. Otherwise it will show
the'' '' icon, then press the '' '' button to stop and wind properly to
measure again.
It will show the '' '' icon, if body moves when measuring. Please measure
again or it will show inaccurate results.
Static mode
This function is mainly for professional personnel to enter the static mode to
test the monitor through standard pressure gauge.
Warning: Normal users don't need to know this function and also do not
operate. The company will not take any responsibility for damage caused by
this operation.
Press the '' '' button after battery installation, then the screen will show the''
'' icon, which means the system is in restore testing. Several seconds later,
the'' ''icon disappears and the air pump starts inflating at the same time,
which indicates the test ended. Then press the '' '' button to stop inflating
and take out the batteries to enter the next step.
Note: It must restore the system before entering the static mode, otherwise
it may cause inaccurate results.
To Next Page
Loading...
