What to do if my Zanussi ZDT22004FA Dishwasher won't start?
If your Zanussi Dishwasher programme does not start, ensure the appliance door is fully closed. If the delay start is active, either cancel it or wait for the countdown to finish. Also, the dishwasher may be undergoing a resin recharge, which takes about 5 minutes.
How to fix a Zanussi ZDT22004FA Dishwasher that won't fill with water?
If your Zanussi Dishwasher isn't filling with water, ensure the water tap is fully open. If the end indicator flashes once and you hear one acoustic signal, this could be the reason. Also, check that the water supply pressure isn't too low. Make sure the water tap and the filter in the inlet hose are not clogged, and the inlet hose isn't kinked or bent.
What to do if my Zanussi ZDT22004FA won't drain water?
If your Zanussi Dishwasher isn't draining water and the end indicator flashes twice with two acoustic signals, ensure the sink spigot is not clogged. Also, check the drain hose for any kinks or bends.
How to fix a leaking Zanussi Dishwasher door?
If there's a small leak from your Zanussi Dishwasher door, the appliance may not be level. Try adjusting the adjustable feet, if applicable. If the door is not centered on the tub, adjust the rear foot, if applicable.
Why does my Zanussi ZDT22004FA Dishwasher keep stopping and starting?
It is normal for the Zanussi Dishwasher to stop and start multiple times during operation. This provides optimal cleaning results and energy savings.
Why is my Zanussi ZDT22004FA Dishwasher door difficult to close?
If you're having trouble closing the Zanussi Dishwasher door, check if the appliance is level by adjusting the feet. Also, make sure no tableware is sticking out from the baskets.
How to stop rattling sounds in Zanussi Dishwasher?
To stop rattling or knocking sounds inside your Zanussi Dishwasher, make sure the tableware is correctly arranged in the baskets, referring to the basket loading leaflet. Also, check that the spray arms can rotate freely.
What to do if Zanussi Dishwasher trips the circuit-breaker?
If your Zanussi Dishwasher trips the circuit-breaker, the amperage might be insufficient for all appliances in use. Check the socket amperage and meter capacity, or turn off another appliance. If this doesn't resolve the issue, there may be an internal electrical fault.
What to do if the anti-flood device is on in my Zanussi ZDT22004FA?
If the anti-flood device is activated on your Zanussi Dishwasher (the end indicator flashes three times intermittently and you hear three acoustic signals), close the water tap.
Safety rules for children and vulnerable users.
General safety rules for the appliance.
Important warnings and steps for appliance installation.
Warnings and guidelines for safe electrical connections.
Instructions for connecting the appliance to the water supply.
Guidelines for safe and correct appliance usage.
Information on service, repairs, and safe appliance disposal.
Details of available wash programmes and their consumption values.
Steps for initial setup including water softener, salt, rinse aid, and water tap.
Solutions for common issues like appliance not starting or filling.
Troubleshooting programme duration, door leaks, and closure difficulties.
Addressing noises, circuit trips, and other electrical issues.
Causes and solutions for unsatisfactory washing results.
Causes and solutions for dishes not drying properly.
General| Type | Freestanding |
|---|---|
| Noise Level | 49 dB |
| Height | 85 cm |
| Width | 60 cm |
| Size | Full Size |
| Number of Place Settings | 13 place settings |
To Next Page