What to do if my Zanussi Dishwasher does not fill with water?
If your Zanussi Dishwasher isn't filling with water, check the following: * Ensure the water tap is fully open. * Contact your local water authority to verify the water supply pressure is adequate. * Make sure the water tap isn't clogged. * Inspect the filter in the inlet hose for clogs. * Confirm the inlet hose has no kinks or bends.
Why my Zanussi ZDT26001FA programme does not start?
If the Zanussi Dishwasher programme isn't starting, make sure the appliance door is properly closed. Also, if the delay start is set, either cancel the setting or wait for the countdown to finish. The appliance may also be recharging the resin inside the water softener, which takes approximately 5 minutes.
What to do if my Zanussi ZDT26001FA won't drain the water?
If your Zanussi Dishwasher is not draining water, check that the sink spigot isn't clogged and ensure the drain hose has no kinks or bends.
How to fix anti-flood device on Zanussi ZDT26001FA?
If the anti-flood device is activated on your Zanussi Dishwasher, close the water tap and contact an Authorised Service Centre.
General| Brand | Zanussi |
|---|---|
| Model | ZDT26001FA |
| Category | Dishwasher |
| Language | English |
To Next Page