What to do if Zanussi ZDT26040FA Dishwasher does not fill with water?
If the display shows an error and your Zanussi Dishwasher isn't filling with water, ensure the water tap is fully open and that the water supply pressure isn't too low. Check that the water tap and the filter in the inlet hose are not clogged, and make sure the inlet hose has no kinks or bends.
What to do if Zanussi Dishwasher does not drain the water?
If your Zanussi Dishwasher display shows an error and the appliance does not drain water, check that the sink spigot, the filter in the outlet hose, and the interior filter system are not clogged. Also, ensure the drain hose has no kinks or bends.
How to fix a leaking Zanussi Dishwasher door?
If you notice a small leak from the door of your Zanussi Dishwasher, it might not be leveled correctly. Try loosening or tightening the adjustable feet. Also, ensure the door is centered on the tub by adjusting the rear foot, if applicable.
Why does my Zanussi ZDT26040FA program last too long?
If your Zanussi Dishwasher program is running longer than expected, you can select the TimeManager option to shorten the program duration. Also, check if the delayed start option is set; if so, cancel it or wait for the countdown.
What to do if my Zanussi ZDT26040FA program does not start?
If your Zanussi Dishwasher won't start, ensure the appliance door is fully closed. Also, if the delay start function is activated, either cancel it or wait for the countdown to complete. The appliance may also be recharging the resin inside the water softener, which takes about 5 minutes.
Why does my Zanussi Dishwasher trip the circuit-breaker?
If your Zanussi Dishwasher trips the circuit-breaker, the amperage might be insufficient for all appliances running simultaneously. Check the socket amperage and meter capacity, or turn off another appliance. If this continues, it could indicate an internal electrical fault, and you should contact an Authorised Service Centre.
Why is my Zanussi ZDT26040FA Dishwasher door difficult to close?
If your Zanussi Dishwasher door is difficult to close, check if the appliance is level by adjusting the feet. Also, make sure no tableware is sticking out from the baskets.
Why does my Zanussi ZDT26040FA Dishwasher make rattling noises?
Rattling or knocking sounds from inside your Zanussi Dishwasher could mean the tableware isn't properly arranged. Refer to the basket loading leaflet for guidance. Also, ensure the spray arms can rotate freely.
What does it mean when the anti-flood device is on in my Zanussi Dishwasher?
If the display shows an error and the anti-flood device on your Zanussi Dishwasher is activated, close the water tap and contact an Authorised Service Centre.
Why does my Zanussi ZDT26040FA Dishwasher keep stopping and starting?
It is normal for the Zanussi Dishwasher to stop and start multiple times during operation. This ensures optimal cleaning and energy savings.
General| Type | Freestanding |
|---|---|
| Energy Efficiency Class | F |
| Capacity | 13 place settings |
| Height | 85 cm |
| Width | 60 cm |
| Category | Dishwasher |
| Energy Consumption per 100 Cycles | 104 kWh |
| Place Settings | 13 |
| Standard Place Settings | 13 |
| Drying Class | A |
| Programs | 6 |
| Delay Start | Yes |
| Half Load | Yes |
| Child Lock | No |
| AquaStop | Yes |
To Next Page