Why is there condensation on the back of my Zanussi ZNHN18FS1?
Too much condensation on the rear wall of your Zanussi Freezer could be because the door was opened too frequently, the door was not closed completely, or stored food was not wrapped. To fix this, open the door only when necessary, ensure the door is completely closed, and wrap food in suitable packaging before storing it in the appliance.
Why is my Zanussi Freezer so noisy?
If your Zanussi Freezer is making unusual noises, it might not be properly supported. Check to ensure that the appliance stands stable.
Why is my Zanussi Freezer leaking water inside?
If water is flowing inside your Zanussi Freezer, it could be because food products are blocking the water from flowing into the water collector or the water outlet is clogged. Ensure that food products do not touch the rear plate and clean the water outlet.
Why is my Zanussi Freezer leaking water on the floor?
If water is leaking onto the floor from your Zanussi Freezer, the melting water outlet is probably not connected to the evaporative tray above the compressor. Attach the melting water outlet to the evaporative tray.
Why is the light not working in my Zanussi ZNHN18FS1 Freezer?
If the lamp in your Zanussi Freezer isn't working, it might be in stand-by mode. Try closing and opening the door.
How to fix a Zanussi ZNHN18FS1 Freezer that does not turn on?
If your Zanussi Freezer isn't turning on, there are a few potential reasons: * The appliance might be switched off. Ensure that you switch it on. * The mains plug may not be correctly connected. Check that the mains plug is properly inserted into the mains socket. * There could be an issue with the mains socket itself. Try plugging in another electrical appliance to see if it works. If not, contact a qualified electrician.
Why won't my Zanussi ZNHN18FS1 door open easily?
If you're finding it difficult to open the door of your Zanussi Freezer, it might be because you tried to reopen it immediately after closing it. Wait a few seconds between closing and reopening the door.
What to do if the alarm is on in my Zanussi Freezer?
If the acoustic or visual alarm is activated on your Zanussi Freezer, it could be due to a few reasons: * The freezer has been recently switched on. * The temperature inside the freezer is too high. * The door has been left open. Ensure the door is closed. If the issue persists, it may relate to the door open alarm or high-temperature alarm.
Why is the lamp not working in my Zanussi ZNHN18FS1 Freezer?
If the light inside your Zanussi Freezer isn't working, it could be due to: * The lamp being in standby mode. Try closing and opening the door. * The lamp being defective.
Why does my Zanussi ZNHN18FS1 Freezer compressor keep running?
If the compressor in your Zanussi Freezer is constantly running, consider the following potential causes: * The temperature may be set incorrectly. * Too many food products were put in at the same time. * The room temperature is too high. * Food products placed inside were too warm. * The door is not closed correctly. * The FastFreeze function is switched on. To resolve this, ensure the temperature setting is correct, allow some time for the freezer to adjust after adding a large amount of food, make sure the room temperature is within the recommended range, let food cool before placing it in the freezer, check that the door is properly closed, and verify if the FastFreeze function is enabled.
General| Category | Freezer |
|---|---|
| Type | Upright |
| Energy Efficiency Class | F |
| Climate class | SN-N-ST-T |
| Control Type | Mechanical |
| Defrosting Freezer | Manual |
| Number of Shelves | 5 |
To Next Page
