Need help?Do you have a question about the zapco Reference 200.2 and is the answer not in the manual?
General| Channels | 2 |
|---|---|
| THD at Rated Power | <0.05% |
| Signal to Noise Ratio | >100 dB |
| Frequency Response | 10 Hz - 30 kHz |
| Crossover | 12 dB/octave |
| RMS Power at 4 Ohms | 100 Watts |
| RMS Power at 2 Ohms | 200 Watts |
| Bridged RMS Power at 4 Ohms | 400 Watts |
ZAPCO's dedication to audio fidelity, quality products, and customer service.
Introduction to the Reference Series, its design principles and performance goals.
Details on internal components like resistors, transistors, and transformers for optimal sound.
Explanation of SymbiLink™ technology for noise-free audio signal transmission.
Damping factor, slew rate, signal-to-noise ratio, and stereo separation.
Clarification of ZAPCO's use of "raw" specifications vs. industry standards.
Essential warnings covering fusing, wiring, hearing protection, and speaker connections.
Guidelines for selecting correct wire gauge and proper amplifier mounting procedures.
Details on input types, gain setting, and signal mode selection.
How to configure the variable crossover and bass equalization features.
Overview of 2-channel models (200.2, 350.2, 750.2) with specs and layout.
Overview of mono models (500.1, 1100.1) with specs and layout.
Overview of multi-channel models (360.4, 1000.4, 650.6) with specs and layout.
Diagrams showing basic full range system configurations for various models.
Diagrams illustrating complex setups like multi-channel, bi-amp, and bandpass systems.
Information on how to contact Zapco for technical help and repair procedures.
To Next Page
