Need help?Do you have a question about the zapco Reference Series 2 and is the answer not in the manual?
General| Channels | 2 |
|---|---|
| THD | <0.05% |
| S/N Ratio | >100dB |
| Frequency Response | 10Hz - 30kHz |
| Crossover | 12dB/octave |
| Dimensions | 2.25" |
ZAPCO's commitment to audio fidelity, product quality, and customer service.
Introduction to the ZAPCO Reference Series amplifiers, highlighting their design philosophy and value.
Explanation of high-quality internal components used for sonic purity in ZAPCO amplifiers.
Details on ZAPCO's balanced line transmission technology for reduced noise and improved signal integrity.
Discussion of key amplifier specifications like Damping Factor, Slew Rate, and Signal to Noise Ratio.
Essential safety guidelines for installing and operating ZAPCO amplifiers, including wiring and sound levels.
Guide to selecting appropriate wire gauges for power and ground connections based on current demand and length.
Recommendations for mounting amplifiers, ensuring proper ventilation, and avoiding vibration for optimal performance.
Details on balanced (SymbiLink) and unbalanced (RCA) input options for ZAPCO Reference Series amplifiers.
Step-by-step guide on properly setting amplifier gain controls to achieve maximum clean output and minimize noise.
Guide to setting the Signal Mode Switch for Stereo, Bridged, or L+R Sum Mono configurations.
Explanation of the variable Bass EQ circuit and its effect on bass response, including equalization curves.
Details on the built-in variable electronic crossovers for high pass, low pass, and full range applications.
Overview, specifications, front panel layout, and key features for the Reference 200.2 amplifier.
Overview, specifications, front panel layout, and key features for the Reference 350.2 amplifier.
Overview, specifications, front panel layout, and special features for the Reference 750.2 amplifier.
Overview, specifications, front panel layout, and key features for the Reference 500.1 amplifier.
Overview, specifications, front panel layout, and key features for the Reference 1100.1 amplifier.
Overview, specifications, front panel layout, and key features for the Reference 360.4 amplifier.
Overview, specifications, front panel layout, and special features for the Reference 1000.4 amplifier.
Overview, specifications, front panel layout, and key features for the Reference 650.6 amplifier.
Wiring diagrams for basic full range and 3-channel systems using Reference 200.2/350.2 amplifiers.
Wiring diagrams for various systems including 4-channel, 3-channel with mono bass, and dual mono configurations.
Wiring diagrams for dual mono highs with mono sub and 4-channel amp with mono bass amp setups.
Wiring diagrams for 750W/Channel mid/high and 1100W mono sub systems, and 2-amp systems.
Wiring diagram for a 3-channel system with subwoofer, featuring 20Hz to 50Hz crossover settings.
Wiring diagrams for 2-amp systems, and 6-channel systems with various crossover and input configurations.
Information on contacting ZAPCO for technical help, troubleshooting, and warranty/repair procedures.
To Next Page