AF2ZP0CL - ACE2 - User Manual Page - 53/85
ACCELERATION 1 parameter.
6) ACC PROF. FREQ 2
In correspondence to this frequency in [Hz] the acceleration is defined by the
ACCELERATION 2 parameter.
7) ACC PROF. FREQ 3
In correspondence to this frequency in [Hz] the acceleration is defined by the
ACCELERATION 3 parameter.
8) RELEASE BRAKING
Seconds. It controls the deceleration ramp when the pump request is
released. The parameter sets the time needed to decelerate the traction
motor from 100Hz to 0Hz.
9) MAX SPEED LIFT
It determines the pump maximum speed when LIFT ENABLE switch is
closed .
10) 1ST SPEED COARSE
It determines the pump maximum speed when SPEED1 switch is closed .
11) 2ND SPEED COARSE
It determines the pump maximum speed when SPEED2 switch is closed .
12) 3RD SPEED COARSE
It determines the pump maximum speed when SPEED3 switch is closed.
13) HYD SPEED FINE
It determines the pump maximum speed when an hydraulic steering function
request is received via CAN BUS.
14) CUTBACK SPEED 1
Speed reduction when the cutback input is active.
15) FREQUENCY CREEP
To Next Page
Loading...
