AEMZP0BA - EPS-AC0 - User Manual Page - 81/95
the full drive speed. It is used for the dynamic numbness (i.e. the steering
sensitivity reduces when the truck speed increases).
26) ENC COUNT AT 360
(only when FEEDBACK DEVICE is OPTION #4).This reading shows the
encoder counting between two falling edges on the straight ahead switch. It
must be meant as the encoder counting corresponding to a steered wheel
revolution. It is scaled in the range 0 to ±5 V with the meaning that 5 V
corresponds to an encoder counting of 2
15
events. The ENC COUNT AT 360
absolute value can be recorded on the adjustment SET ENC AT 360.
To Next Page
Loading...
