Zapi ZAPIMOS Series - 2 General Characteristic; Technical Specification; Control Units; Microswitches

Page 5
2 GENERAL CHARACTERISTIC
2.1 TECHNICAL SPECIFICATION
Chopper for Separately Excited DC motors ...................................................2.5 ÷ 5.5kW
Regenerative Braking.
Voltage Range ......................................................................................24 to 48 Volts DC
Maximum Field Current (all the versions.............................................................50 Amps
Armature Switching Frequency ...............................................................................16kHz
Field Switching Frequency ........................................................................................1kHz
Maximum Ambient temperature .............................................................................+ 40°C
Minimum Ambient temperature ................................................................................-30°C
Maximum temperature of Chopper ........................................................................+ 85°C
Resistance of field Winding ............................................................................. 0.3 to 0.6W
VERSION MAXIMUM CURRENT BOOSTER CURRENT
VOLTAGE DROP AT
TOTAL CONDUCTION
24V / 500A 500A 580A 0.25V at 200A, 25°C
36V / 500A 500A 580A 0.25V at 200A, 25°C
48V / 350A 350A 400A 0.25V at 100A, 25°C
2.2 CONTROL UNITS
2.2.a Microswitches
- Microswitches should have a contact resistance lower than 0.1W , and a leakage
current lower than 100 µA.
- When full load current is being drawn, the voltage drop across the Key Switch con
tacts must be lower than 0.1V.
- If an Electromagnetic Brake is used, the Handle Microswitch must operate the Brake
Coil.
- The Microswitches send a voltage signal to the microprocessor when an operating
request (running) is made.