Operating and assembly instructions
Z200 / Z300
22
5.4. Inspections of the scaffold components
If a defect is discovered, the affected part may not be used any longer.
Slip-in frame / chassis beams
• Check for deformation, crushing and crack formation.
Braces (diagonal / railings)
• Check for deformation, crushing, crack formation and function of the catches.
Platform
• Check for deformation, crushing, crack formation and function of the catches.
• Check state of the wood.
• Check pass-through fl ap for function.
Toe boards
• Check state of the wood.
• Check toe boards for crack formation.
Swivel castors
• Check rolling capacity of the castor and function of the brake on rolling and
basic frame.
• For swivel castors with spindle, also check that spindle can move freely.
• Check fail safe (thumb screw, plug) on the chassis beams and and basic frame.
Safety springs
• Check for deformation, crushing, crack formation and tight fi t.
If you would like information or if you have special
problems that are not treated in suffi cient detail in these
operating and assembly instructions, you can request
the required information directly from the manufacturer
(see section 1.2).
Furthermore, we hereby notify you that the content of
these operating and assembly instructions is not part of an
earlier existing agreement, covenant or a legal relationship
nor should it change these. All obligations arise from
the respective purchase contract, which also contains
the complete and solely-valid warranty regulation (see also
section 1.4). These contractual warranty regulations are
neither extended nor limited by the details of these operating
and assembly instructions.
The propagation and duplication of these documents,
the exploitation and communication of their content are only
permissible with the express permission of the manufacturer.
Violations which contradict the details above are subject to
punitive damages.
Z200-300-AA-RC4_EN.indd 22Z200-300-AA-RC4_EN.indd 22 28.02.2008 10:21:5128.02.2008 10:21:51
To Next Page
