Follow the steps to enable the scanner SPP Slave mode.
SPP Slave Mode
In this mode, the scanner connects to the host /PC via wireless connection and
performs like there’s a serial connection. In SPP Slave mode, the scanner is
discoverable from a remote device and it can request the scanner for connection.
To enable SPP slave mode:
1. Power on the scanner and scan the "Start of Conguration" label.
Start of Conguration
2. Scan the “SPP Slave mode” label.
Scanner SPP Slave enable
3. Scan the "End of Conguration" label.
End Of Conguration
Wireless Handheld Gun Type Scanner
Quick Connection Guide
Version 1.00
ASCII Code 39 Table
Getting Started
Setting up the scanner
To Next Page
